Table Saw Finish Side Up

If for example you run out of 80 grit sanding discs halfway through the initial sanding you might be tempted to switch to 100 grit.

Table saw finish side up.

Face up on a table saw face. As with any saw cut keep in mind which side of the line you wish to cut. To help you remember in the future you want the teeth to enter the wood on the good side exit on the less good side. You want the teeth pulling the fibers into the wood for best cut side not pulling the out.

The finished side of your wood must be at the bottom. No matter what reason it is we are here to assist you with how to set up a table saw from start to finish. Whenever you run wood through a table saw always make sure that your finished side is up. Do the exact opposite when you are using your power saw.

When you use a mitre saw make sure the finished side of the wood is facing forward. To get the cleanest cut possible remember these tips. Meanwhile the top face suffers tear out so bad it cannot be used in a visible area on a project. This is one thing to keep in mind as these are simply basic table saw assembly instructions that are for the most typical of saws on the market.

Any variation in sanding steps can show up in the final finish. Jeff you want to cut it good side down with a skill saw in my book unless you have a zero insert type skill saw like the festool the ripping on the table saw would be good side up. Sand every square inch the same. For table and miter saws invest in an 80 tpi plywood blade one designed for cross miter saw or rip table saw cuts.

The kerf on a typical table saw is an eighth of an inch wide so cut ting to the wrong side of the line will result in a. Depending on which saw you own however locations of parts on the saw and results may vary. Be sure the good face of your plywood is closer to the outside of the blade. Because a circular saw blade cuts on an upward rotation the bottom face in which the teeth enter the cut will almost always have a clean tear out free surface.

Since saw blades tend to splinter material as they exit the wood run laminate flooring planks with the good side facing up. That s why a table saw is handled opposite a circular skil saw. But you could use a table saw for the crosscutting as well with help of another person. That way any splintering occurs out of sight on the side that faces.

So on a table saw the right side should be facing up and when using a handheld circular saw it should be facing down.