Roof Drip Edge Installation After Shingles

Drip edging is a strip of flashing that is applied to the edge of roofing prior to the installation of other items.

Roof drip edge installation after shingles.

Use a flat pry bar and hammer to pry the nails out of the drip edge gently. Gently lift up the shingles on the edge of the roof and locate the nails holding the existing drip edge onto. Select enough lengths of. Slowly lift a shingle that is closest to the apex of the roof.

Windy september 22 2017 4 11pm 10. You may need to nail through the starter strip into the drip edge. Be sure to tuck the drip edge under the starter strip and felt paper. Gently slide the flatter side of the drip edge under the eave.

Slide the corner tight to the fascia. How to install a drip edge. Measure the length of the eave you need to cover with drip edge using a tape measure. If it doesn t pull the drip edge out slightly from under the shingles.

Now that the roof is applied it is much more difficult invasive time consuming to install the drip edge being 3 stories only makes it much worse. Secure the drip edge with roofing cement. Install the starter course. It can be done.

Install roof drip edge along the eaves add underlayment then place drip. The starter course is comprised. Make sure the outer edge extends over the gutter. Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge.

Install the drip edge by fitting it on the roof eave pushing it tightly against the edge of the plywood and. Place the metal roof drip edge flashing along the gable ends. It is designed to protect the roof s sheathing from water damage caused by rain snow or ice being blown or rolling back beneath the edge of the shingles. Save yourself some.

Make sure to support the long end of the cut if you let it fall after cutting it will bend down and kink the drip edge. Using drip edge with a nailing edge approx. 4 deep nail the drip edge to the sheathing every 16 if installing multiple runs of drip edge lap them by 1 4 1 2 inch keeping the nail back from the lapped joint. How to fix a roof drip edge installing roof drip edge flashing properly.

Once free slide the drip edge out and discard. This will allow for expansion and contraction and prevent buckling. How to install drip edge flashing on a roof step 1. Using a utility knife cut back the front end of the drip edge.

Apply a continuous bead of cement along the top of the drip edge then press down on the shingle. Push the drip edge a bit so that it passes under the shingle and appears from its other side. Once all the underlayment is applied go back and place.